🧭 Introduction: Why Land Rover Owners Are Seeing “Key Not Found” or “No Start”

Modern Land Rover and Range Rover models rely heavily on electronic immobilizer systems — mainly the KVM (Keyless Vehicle Module) and RFA (Remote Function Actuator).
When either of these modules fails or loses synchronization with your smart key, you’ll often see messages like:

❌ “Smart Key Not Found”
❌ “Press Brake to Start” (but nothing happens)
❌ “Key Not Recognized”

These symptoms often lead to no-start conditions that can leave the vehicle stranded.

🔍 Common Causes of Land Rover No-Start or Key Detection Issues

KVM / RFA Module Corruption – The most frequent cause. Internal memory corruption or failed flash can cause the module to lose pairing with existing keys.
Key Data Loss – Dead batteries or improper jump starts can desynchronize key data stored in the KVM.
Water Damage or Shorted Wiring – The KVM module is often located in moisture-prone areas (such as under the rear seat or trunk floor).
Attempted Programming Gone Wrong – Incorrect tool use (aftermarket programmer) can corrupt EEPROM data or partial-erase the KVM, making the keys unreadable.

🧠 How ECUMedics Diagnoses & Repairs the Problem

At ECUMedics, we specialize in mail-in electronic repair and cloning of Land Rover and Jaguar security modules.
Our process includes:

✅ Full KVM data extraction & integrity check
✅ EEPROM and Flash verification to identify corrupted sectors
✅ Key testing to confirm if your smart key transponder is still active
✅ Cloning or re-synchronization of your original KVM or RFA module
✅ Return ready to plug & start — no dealer reprogramming required

Whether you have a Range Rover Sport, Velar, Evoque, or Discovery — if it says “Key Not Found,” our lab can help.

🛠️ What You Can Mail In

We accept the following for service:

Your KVM or RFA module
One or more original or replacement keys
(Optional) Vehicle VIN and brief description of the issue

Once received, our technicians bench-test the components, clone the data as needed, and return them pre-paired.

🚀 Why Choose a Mail-In Service Instead of a Dealer Visit

Dealer Visit	ECUMedics Mail-In Service
Requires vehicle on site	Ship only your module + key
Re-programming can cost $1,000+	Typically under $300–$500
May replace modules unnecessarily	We repair & clone your existing one
Limited diagnostic time	Dedicated bench-level analysis

🧭 Supported Models

We support most Land Rover & Jaguar models with smart keys, including:

Range Rover Sport / L494
Range Rover L405
Discovery 4 / 5
Evoque
Velar
Jaguar XF, XJ, XE, F-Type

💡 Tip for Technicians

If you’re a shop diagnosing these vehicles:

Always verify 12V and CAN communication to the KVM before assuming failure.
If key data reads as blank or corrupted on scan tools — stop and send the module before further attempts.
ECUMedics can often recover lost data and avoid total immobilizer resets.

📨 How to Get Started

Visit our service page here:
👉 Land Rover / Jaguar KVM Key Programming & Cloning
Select your service type (key test, programming, or full KVM clone).
Follow the mail-in instructions at checkout.
We’ll handle the rest — testing, repairing, and returning your module ready to start your vehicle.

⚠️ Important Disclaimer

This service is intended for legitimate repair or replacement purposes only. ECUMedics does not bypass or remove immobilizer systems — all work is performed in compliance with security and data-protection standards.

Still stuck with “Key Not Found”?

👉 Mail in your KVM or RFA module today — we’ll test and repair it within 24-48 hours.

🔑 Land Rover Key Programming & No-Start Fix – KVM / RFA Module Solutions